RTK Network Configuration
IMPORTANT:
Anytime the radio is reconfigured or changed, power must be cycled at the GPS receiver before continuing. The receiver must be receiving a 3-D position mode.
Radio Channel - RTK
NOTE:
10 Radio Channels are available. The default Radio Channel is 1.
Press input box and enter value (1 - 10)
The Radio Channel may be changed if other RTK systems are operating in area interference is causing decreased base station communication performance.
Network ID › RTK
NOTE:
4000 network ID's are available, default ID is 1.
Press input box and enter value (1 - 4000)
Network ID for base station and vehicle receiver must match. If more than one base station with same Network ID numbers are within range, vehicle may lock on to either one of the base stations. To prevent this from happening, be sure to use unique network ID.
Repeater › RTK
NOTE:
Radio can be configured to act separately as repeater. A repeater is required if obstructions (i.e. trees, hills, etc) exist between base station and vehicle(s).
A repeater consists of
-
Radio (configured as a repeater)
-
Harness
-
Mounting Bracket
-
12 volt Power Source
To configure radio as repeater:
|