Repeater

NOTE: The radio can be configured to act separately as repeater. A repeater is required if obstructions (i.e. trees, hills, etc.) exist between base station and vehicle(s).

A repeater consists of:

  • Radio (configured as a repeater)

  • Harness

  • Mounting Bracket

  • 12 Volt Power Source

To configure radio as repeater:

Screen: SETUP - RTK

Press: SETUP >> STARFIRE ITC >> DIFF CORRECTION SETUP >> RTK SETUP

1. Connect radio to receiver RTK harness.

2. Check that receiver has GPS position calculated.

3. Check that base station, vehicle, and repeater have same Frequency, Network ID and Radio Channel.

4. Press letter button next to CONFIGURE REPEATER RADIO.

5. Radio will configure as repeater.

6. Disconnect repeater from receiver and wiring harness.

7. Reconnect original radio.

PC9736

SETUP - RTK


A-RTK Operating Mode
B-RTK Radio Channel
C-RTK Network ID
D--
E-Radio and Repeater Configuration
F--
G-Return to Differential Corrections Setup

JS56696,00005D2 -19-13MAY09-1/1