Manually Adjusting Calibration Factor

Screen: SETUP—YIELD CALIBRATION

Select: SETUP >> HARVEST MONITOR >> YIELD CALIBRATION

NOTE: Do not perform a manual adjustment of Calibration Factor if you intend on using Low Flow Compensation procedure.

If scale weight is more than 50% higher or lower than displayed weight, system will not allow entry of scale weight.

A new calibration factor can also be entered manually. To calculate calibration factor, divide weight shown on display by new weight on scale ticket. Multiply result by displayed calibration factor (see example below). This is the new calibration factor.

To manually enter a calibration factor:

1. Select CALIBRATION FACTOR button to change calibration factor.

2. Using numeric keypad, input calibration factor.

3. Select CALIBRATION FACTOR button to enter a new value.

Displayed Calibration Factor = 950

Weight of grain shown on display = 27,643 lb

Net weight of grain from scale ticket = 27,022

Displayed Calibration Factor (950) X Weight of grain shown on display (27,643 lb) / Net weight of grain from scale ticket (27,022 lb) = New Calibration Factor (971)

New Calibration Factor = 971