Recording Sources for UPM

The display will allow the operator to choose from an input list which source or function will indicate that recording is on or off. The PM will use this status to know when to engage the various measurements and this value will be in sync with the GreenStar Application.

PC9058-UN-17APR06

Manual

When this item is selected, the operator can manually trigger and stop the recording button, located to the left of the recording source list. This choice is always available.

PC9059-UN-17APR06

Rear Hitch

This choice is only available if the vehicle is equipped with a rear hitch. CCD based vehicles with UPM Rear Hitch Recording is non-adjustable; In-work (recording on) below 70%, and out-of-work (recording off) above the 70% down threshold.

PC9060-UN-17APR06

Front PTO

This item is only available in the list if the vehicle is equipped with a Front PTO.

PC9061-UN-17APR06

Rear PTO

This item is only available in the list if the vehicle is equipped with a Rear PTO.

PC9062-UN-17APR06

Implement Switch Closed

This item is always available and functions based on the position of the implement switch.

PC9063-UN-17APR06

Implement Switch Open

This item is always available and functions based on the position of the implement switch.

PC9064-UN-17APR06

AUTO

If a John Deere implement is connected to the system that is broadcasting its work status, this item will be selected in this list and then the rest of the list will be disabled.

PC9065-UN-17APR06

SCV I-VI

The user can assign any SCV to turn the recording source on. These selections will only show up if the vehicle has the corresponding SCV’s. (Selective Control Valves for the Hydraulics)