Startup Requirements

PC14926-UN-27APR12

Application Controller 1100 Button

NOTE: Shared signal requires a GreenStar™ 3 2630 Display and StarFire™ 3000 Receiver on machine and implement.

StarFire™ iTC Receivers require RTK.

• StarFire™ Receivers with RTK on machine and implement if shared signal is not used. NOTE: If using StarFire™ 3000 Receivers on machine and implement, shared signal automatically engages even if using RTK on both. Turn off RTK on implement receiver when using shared signal.
  
• Shared signal requires:
  • SF2 or RTK activation on machine receiver.
  • SF1, SF2, or RTK on implement receiver.
• Active Implement Guidance hardware installation complete.
• StarFire™ receiver software updated to latest version.
• Implement steering active on the application controller.
• NOTE: When calibrating TCM on machine and implement, put implement in lowered (working) position.
  Machine and Implement receivers setup and TCM calibration complete.
• AutoTrac™ set up complete and activated on display.
• SCV flow rate adjusted.
• SCV threshold calibrations performed.
• Left, right, center calibrations done if using implement steer.
• Extend on SCV results in an increasing wheel angle sensor voltage.
• Requirement to Engage Active Implement Guidance defined.
• Active Implement Guidance Sensitivities adjusted.
• Implement Receiver offsets entered.