|
StarFire Receiver Detected
|
A new StarFire receiver has been detected. Please go to the
StarFire application and calibrate the receiver.
|
|
GPS Communication Problem
|
No communication with GPS receiver. Check connection at GPS
receiver and perform operation again.
|
|
GPS Communication Problem
|
No GPS position available. Verify GPS receiver has clear view
of sky.
|
|
GPS Communication Problem
|
No GPS differential correction available. Verify GPS receiver
has clear view of sky.
|
|
GPS Communication Problem
|
2D GPS in use. Verify GPS receiver has clear view of sky.
|
|
Curve Track Memory Full
|
Internal memory available for Curve Track is full. Data must
be cleared to continue Curve Track Operation. Clear curved track data
from system
|
|
AutoTrac Disabled
|
AutoTrac SF1 license cannot operate with current StarFire software.
Update StarFire software to operate AutoTrac.
|
|
AutoTrac Disabled
|
AutoTrac SF1 license cannot operate while SF2 corrections are
turned on. Turn SF2 corrections off to operate AutoTrac.
|
|
License Problem
|
No license available for the selected tracking mode. Previous
tracking mode will be selected.
|
|
Duplicate Name
|
Name already exists. Select another name.
|
|
Curve Track Recording
|
Curve Track recording in progress. Cannot perform operation
until recording is turned off.
|
|
Curve Track Memory Low
|
The internal memory available for Curve Track is almost full.
Clear curve track data.
|
|
AB Curve Too Far
|
Vehicle must be within 1/4 mile (400m) of recorded AB Curve
to generate path.
|
|
Circle Definition Problem
|
There was an internal error during Circle definition. Redefine
the circle.
|
|
Circle Definition Problem
|
Communication with GPS receiver was lost during circle definition.
Redefine the circle once communication has been re-established.
|
|
Circle Definition Problem
|
Center point is too far. Select another center point.
|
|
Circle Definition Problem
|
The distance from the vehicle to the center point is greater
than 1 mile. Select another center point or drive another circle.
|
|
A-B Line Definition Problem
|
There was an internal error during A-B line definition. Redefine
the A-B line.
|
|
A-B Line Definition Problem
|
A timeout occurred during A-B line definition. Redefine the
A-B line.
|
|
A-B Line Definition Problem
|
A and B points of the AB Line are too close. Must have 10 ft
(3 m) between point A and B. Perform operation again.
|
|
Invalid GPS Coordinate
|
The entry is invalid. Enter a value between -90.0 and 90.0
for Latitude and between -180.0 and 180.0 for Longitude.
|
|
Loss of GPS While Recording Boundary
|
GPS has been lost while recording the boundary. Point logging
will resume when the GPS signal returns. This may result in an inaccurate
boundary.
|
|
Processing Data
|
Processing data. Please wait...
|
|
Internal Memory Full
|
The internal memory is almost full.
Please insert a USB device to transfer and remove data from
the internal memory. Clearing Guidance Curve Track data may also
create space in memory.
Alternatively, select ‘A’ to use the Data Cleanup tool to create
additional space.
|
|
No Memory
|
No Memory available for Curve Track. Unload data to USB drive
or clear space in memory.
|
|
No Memory
|
No Memory available for Straight Track. Unload data to USB drive
or clear space in memory
|
|
No Memory
|
No Memory available for Circle Track. Unload data to USB drive
or clear space in memory
|
|
Low Memory
|
Low Memory available for Curve Track. Unload data to USB drive
or clear space in memory
|
|
Zero All Totals
|
You have decided to zero all totals for the selected filter.
|
|
Prescription Error
|
Controller is not setup to accept prescriptions.
|
|
Prescription Error
|
Controller is setup to accept prescriptions. No controller prescription
has been selected.
|
|
Prescription Error
|
Prescription rate is out of controller range.
|
|
Controller Unit of Measure Error
|
Controller will only operate when using metric units.
|
|
Controller Unit of Measure Error
|
Controller will only operate when using English (US) units.
|
|
Controller Unit of Measure Error
|
Controller will only operate when using metric or English (US)
units.
|
|
Prescription Alert
|
Out of field prescription rate is now being applied.
|
|
Prescription Alert
|
Loss of GPS signal has occurred. Loss of GPS prescription rate
is now being applied.
|
|
Prescription Alert
|
Controller does not support selected prescription.
|
|
New Implement Detected
|
A new implement has been detected that requires a different
documentation task. Please revisit the setup wizard to use documentation.
|
|
Controller Operation Error
|
Invalid operation selected for controller.
|
|
Implement Documentation Not Supported
|
The system does not support documentation for multiple-operation
implements. Documentation can be performed for a single task only.
|
|
Unsupported Implement
|
The current implement does not support Swath Control Pro
|
|
Unsupported Operation
|
Current SprayStar Software does NOT support Swath Control Sections.
Please contact your local John Deere Dealer to obtain the latest SprayStar
software updates.
|
|
Field Coverage Map Almost Full
|
The coverage map memory is almost full. When completely full,
coverage will no longer be recorded. To record new coverage, perform
one of the following as soon as possible:
To save coverage for this field, pause recording and change
to a new field (Recommended).
To continue with current guidance lines and/or boundaries, delete
coverage by pressing the "Clear Current Field Map" button below.
|
|
Field Coverage Map Full
|
Coverage map memory is full. Coverage will no longer be recorded.
To record new coverage, perform one of the following:
To save coverage for this field, pause recording and change
to a new field (Recommended).
To continue with current guidance lines and/or boundaries, delete
coverage by pressing the "Clear Current Field Map" button below.
|
|
Accuracy Loss
|
You have recorded a GPS point farther than 20 miles away. Coverage
accuracy will decrease. Clear your coverage map, create a new field,
or change to a different field to restore accuracy.
|
|
Accuracy Loss
|
You are more than 20 miles away from your selected guidance
track. Guidance accuracy will decrease. Create a new guidance track
or change to a different track to restore accuracy.
|
|
Accuracy Loss
|
You have recorded a GPS point farther than 20 miles away. Coverage
and guidance accuracy will decrease. Create a new field or change
to a different field to restore accuracy.
|
|
Coverage Recording Disabled
|
Coverage recording is disabled during data transfers
|
|
USB Detected
|
The GreenStar application is disabled while a USB device is
present.
To resume using the GreenStar application, remove the USB device.
To transfer GreenStar data to/from the USB device, press the
“Transfer Data” button.
|
|
Cannot Backup File
|
There is not enough space on the USB device to backup data.
Please delete data from the USB device or insert a different USB
device.
|