Loading Software

Do not turn off power or remove USB drive while display is reprogramming. Doing so can damage display and put software in an irrecoverable state.

Verify that display has the latest software available. To acquire the latest software visit www.StellarSupport.com or contact a John Deere dealer.

After new software has been downloaded to USB drive, simply insert USB drive in to USB port on the display and system will show a screen prompting operator to reprogram display. If operator does not choose to reprogram system, reprogramming alarm will appear during every power-up cycle if the USB drive is still inserted.

To install this software update, select the button to continue. The following messages will appear on the screen:

• Updating software - Warning: Do not power down display or remove USB drive.
• The update was successfully installed. Select the button to continue. - Please cycle power.
• The system is restarting, please wait.
• If software update was unsuccessful this message will be given: The software update was unsuccessfully. See the message center.

To manually load a different software version to a component:

• Choose component from list on Message Center - Reprogram Device Screen
• Push REPROGRAM DEVICE button
• Choose software version from the drop-down box and select enter.