Enabling AutoTrac

PC10857LA-UN-14APR09

Steer On/Off Softkey

• Vehicle has an AutoTrac capable steering controller (SSU)
• Valid AutoTrac Activation (26digit Activation Code)
• Setup Wizard is complete and a guidance track has been created. See the GETTING STARTED section earlier in this manual for Setup Wizard information and see the sections on each Guidance Mode for information on creating guidance tracks.
• Correct StarFire signal level for AutoTrac Activation is selected (SF1, SF2, or RTK) and a valid GPS signal is acquired.
• TCM turned on and TCM message is valid
• SSU has no active faults pertaining to the steering function.
• Hydraulic oil warmer than minimum temperature
• Tractors - above 20°C (68°F)
• Forward vehicle speed is less than 30 km/h (18.6 mph)
• Reverse speed is less than 10 km/h (6 mph)

To Enable AutoTrac, select the Steer On/Off softkey located on the Run Page. This softkey will disable AutoTrac if selected again.