RADAR CONNECTION SIGNAL VALIDATION (BPM MODE ONLY)

Ensure the radar connected check box is checked in the BPM setup screen. This check box will only display in BPM mode. In APM mode, radar feed is designated by the wire connection behind the command center denoted in the Configuring Tractor section. The GS2 display will display the GPS radar feed value when connected. This value should be 57.42 during normal operation. To view this value once connected:

1. Select Menu > Message Center > Diagnostic Addresses (Softkey G).

2. In the Device drop down list, select VTi.001 Implement.

3. Scroll down to Address 60.

4. Address 60 should display 57.42 if radar is feeding from the iTC GPS receiver If this value is 57.42, you are directly feeding GPS radar signal. Ground based radars will display approximately the same values when connected.

If zero is displayed, no radar signal is being seen, GPS nor Ground Based.