Main Page Display

PC14151-UN-01NOV11


PC14152-UN-01NOV11

Main Page Display

A - Information Drop-Down Menu

B - Enable Agitator

C - Agitator Status Icon

D - Enable Pump

The Information drop-down menu includes:
• Productivity (Area per hour).
• Estimated time remaining on current tank level.
• Estimated area remaining on current tank level.
• Flow per minute.
• Area Covered.
• Total Product Applied.
• Average Application Rate.
• Speed
• Pressure Sensor 2

The estimated time and area values are an instantaneous calculation based on current tank level. Estimated time and area values can be expected to fluctuate due to changes in flow rate, working width, or speed while operating.

NOTE: Flow per minute is only an option when pressure sensor is installed.

Area Covered, Total Product Applied, and Average Application Rate can be zeroed on the Reports and Totals Softkey H >> Current Tab.

Pressure Sensor 2 is only an option when two pressure sensors have been configured

Information drop-down menu will be displayed if Pump Enable Checkbox was not selected in PWM Settings.

To activate agitator check the Enable Agitator box (B).

The agitator icon (C) changes from grey to white when active.