Daily Checklist

□  Inspect wiring harness for wear and damage around pinch points, corners, edges, and harness support locations. Repair as necessary.

□  Inspect wiring harness at connectors for wear on exposed wires. Repair as necessary.

□  Inspect mounting hardware. Retorque as necessary.

□  Display

□  Controller mount

□  Run controller diagnostic tests.

□  Perform Control Valve test.

□  Verify section status readings.

□  Verify system voltage readings.

□  Verify switches and status readings.

□  Verify sensor and status readings.

(Reference implement Operator’s Manual for detailed checklists.)

NOTE: When changing product, empty bin or tank, perform rinse cycle, and perform new product setup and calibration.

Some tests are not available depending on application.