Installation in a John Deere Vehicle with an ISOBUS Display

One John Deere ISOBUS display may be installed on corner post of a John Deere machine with ISOBUS display compatible armrest. Compatible John Deere machines with CommandCenter™ displays are:

  • 6R Tractors
  • 7R Tractors
  • 8R Tractors
  • 9R Tractors
  • S Series Combines

John Deere ISOBUS displays that can be installed on corner post include:

  • GreenStar™ 2 1800
  • GreenStar™ 2 2100
  • GreenStar™ 2 2600
  • GreenStar™ 3 2630

Some applications on armrest display will automatically turn off because they cannot run on two displays on the same CAN bus. User may turn implement bus (Virtual Terminal functionality) On or Off on armrest display, depending on their preference. Virtual Terminal (VT) is part of the software that displays graphic user interfaces of John Deere planters or other ISOBUS implements.

Installation

  1. Turn off vehicle.

  2. Attach display harness to the corner post connector and the 26-pin display connector on the back of the display.

  3. Turn on vehicle. The armrest display may display a message stating that another John Deere display has been detected. If it does not, see the vehicle Operator’s Manual to check that the Multiple Display settings are set correctly on the armrest display.

  4. Restart the vehicle so that both displays can reboot.

When both displays power up, some applications are set to On or Off on each display, as shown in the table below. If the armrest display Mode, found on the Multiple Display Settings page is set to Custom and the applications are not set as desired, select Restore To Default Settings on the Multiple Display Settings on the armrest display.

Default Multiple Display Configuration

Application

Corner Post Display

Armrest Display

GreenStar

On

Off

Original GreenStar Display Emulator

On

Off

Implement Bus

On

Off

Controller Programming

On

Off

Task Controller

On

Off

Implement bus is the only application that user can configure to be On or Off on armrest display. Uncheck implement bus to disable VT. If VT is disabled, user interface for implement is displayed on secondary display.

Check implement bus to enable VT. If VT is enabled, user can decide on which display the graphic user interface of the implement should be displayed.

NOTE: Armrest display may not function properly if a third-party display is connected to Implement bus. It is recommended to install a second CAN bus if problems occur. See CAN bus section of this Operator's Manual for more information about CAN bus.

See View Multiple Display Settings section on next page to find out how to access these values.

CommandCenter is a trademark of Deere & Company
GreenStar is a trademark of Deere & Company

AE77568,00000EA-19-20150727