Turn Predictor

Turn predictor is intended to only predict turn point of a vehicle using Parallel Tracking or AutoTrac. It is NOT a headland alert. Because actual field boundary is unknown, turn predictions are based solely on previous turn behavior of vehicle. Turn predictions will not coincide with field boundary if field boundary is not linear and continuous, or if operator makes turns before or after field boundary.

NOTE: Turn predictor cannot be turned off if no seat switch is present on the vehicle.

Parallel Tracking—Turn Predictor will default to ON. To turn off go to MENU >> GREENSTAR 3 PRO button >> GUIDANCE softkey >> GUIDANCE SETTINGS tab. Deselect the check box. Once turned OFF, it will remain off through power cycles until manually turned back on by operator. Turn OFF will be displayed on guidance screen when turn predictor is turned off.

AutoTrac—Turn Predictor will default to ON after every power cycle or after every seat switch time-out. To turn off go to Menu >> GREENSTAR 3 PRO button>> GUIDANCE softkey >> GUIDANCE SETTINGS tab. Deselect the check box. Turn Predictor cannot be turned off on vehicles with out an operator presence switch tied to CAN line. Once turned OFF, it will remain off only until next power cycle, seat switch time-out, or if manually turned back on by operator. Turn OFF will be displayed on guidance screen when turn predictor is turned off.

Whenever Display resets Turn Predictor back to ON after a seat switch time-out (operator out of seat for 7 seconds on tractors, 5 seconds on combines and sprayers), it will display an alert indicating Turn Predictor has been reset to ON due to operator leaving seat. An option will be available allowing the operator to turn it OFF again from the alert screen.