|
523319.18
|
Low switched voltage
|
low voltage on key switched power supply.
|
Check battery voltage, check grounds, check harness. Contact
dealer if problem persists.
|
|
523792.18
|
Low unswitched voltage
|
TCM has detected low voltage on unswitched battery power supply.
|
Check battery voltage, check grounds, check harness. Contact
dealer if problem persists.
|
|
523792.1
|
No unswitched voltage
|
TCM has detected no voltage on unswitched battery power supply.
TCM is unable to save setup changes when key is turned off.
|
Check battery voltage, check grounds, check fuses and harness.
Contact your John Deere dealer.
|
|
2028.12
|
No STARFIRE communication
|
TCM has lost communication with STARFIRE receiver
|
Check TCM harness to ensure proper connection between STARFIRE
Receiver and TCM. Check CAN voltages. Contact your John Deere dealer.
|
|
523773.3
|
StarFire CAN voltage out of range
|
StarFire CAN High signal voltage is out of range high.
|
Check TCM harness to ensure proper connection between STARFIRE
Receiver and TCM. Check CAN STARFIRE voltages. Contact your John Deere
dealer.
|
|
523773.4
|
StarFire CAN voltage out of range
|
StarFire CAN High signal voltage is out of range low.
|
Check TCM harness to ensure proper connection between Receiver
and TCM. Check CAN voltages. Contact your John Deere dealer.
|
|
523774.3
|
StarFire CAN voltage out of range
|
StarFire CAN Low signal voltage is out of range high.
|
Check TCM harness to ensure proper connection between STARFIRE
Receiver and TCM. Check CAN voltages. Contact dealer.
|
|
523774.4
|
StarFire CAN voltage out of range
|
StarFire CAN Low signal voltage is out of range low.
|
Check TCM harness to ensure proper connection between STARFIRE
Receiver and TCM. Check CAN voltage. Contact your John Deere dealer.
|
|
956.16
|
Roll Sensor out of range
|
Internal Roll Sensor is out of normal operating range. TCM cannot
correct position for roll angles.
|
Contact your John Deere dealer.
|
|
2146.14
|
Temp Sensor out of range
|
Internal Temperature Sensor is out of normal operating range.
|
Contact your John Deere dealer.
|
|
523309.7
|
Yaw Sensor not responding
|
Internal Yaw Sensor is not responding. TCM cannot compensate
for terrain changes.
|
Contact your John Deere dealer.
|
|
523309.16
|
Yaw Sensor out of range
|
Internal Yaw Sensor is out of normal operating range. TCM cannot
compensate for terrain changes.
|
Contact your John Deere dealer.
|
|
523310.2
|
Memory Error
|
An internal memory error has occurred.
|
Contact your John Deere dealer.
|
|
523442.31
|
No StarFire Fore/Aft setting
|
StarFire Fore/Aft setting has not been entered for this vehicle.
Please go to SETUP TCM.
|
See FORE/AFT in TCM or StarFire 3000 section.
|
|
523441.31
|
No StarFire Height setting
|
StarFire Height setting has not been entered for this vehicle.
Go to SETUP TCM.
|
See HEIGHT in TCM or StarFire 3000 section.
|
|
2146.13
|
TCM not calibrated
|
TCM has not been calibrated for this vehicle. Please go to SETUP
TCM to calibrate.
|
See Calibrating in TCM or StarFire 3000 section.
|