|
158.03
|
Keyswitch Battery Potential
|
3
|
Voltage Above Normal or Shorted to High Source
|
Amber Warning Lamp
|
The StarFire is operating with high switched voltage. Check
wiring.
|
System Voltage
|
Switched power > 32V. Check vehicle charging system,wiring,
and connections
|
|
158.04
|
Keyswitch Battery Potential
|
4
|
Voltage Below Normal or Shorted to Low Source
|
Amber Warning Lamp
|
The StarFire is operating with low switched voltage. Check
wiring.
|
System Voltage
|
Switched power <9V. Check vehicle battery, harnessing and
connectors.
|
|
168.03
|
Battery Potential/Power Input 1
|
3
|
Voltage Above Normal or Shorted to High Source
|
Protect Lamp
|
Unswitched power to GPS receiver has high voltage.
|
System Voltage
|
Unswitched power > 32V. Check vehicle charging system, wiring,
and connections.
|
|
168.04
|
Battery Potential/Power Input 1
|
4
|
Voltage Below Normal or Shorted to Low Source
|
Protect Lamp
|
Unswitched power to GPS receiver has low voltage.
|
System Voltage
|
Unswitched power < 9V. Check vehicle charging system, wiring,
and connections.
|
|
232.02
|
DGPS Differential Correction
|
2
|
Data Erratic, Intermittent, or Incorrect
|
Amber Warning Lamp
|
Corrected GPS position is not available.
|
GPS System
|
Corrected GPS position is not available.
|
|
444.04
|
Configuration
|
4
|
Special Instructions
|
Amber Warning Lamp
|
Invalid application configuration
|
Configuration
|
Invalid application configuration
|
|
639.12
|
J1939 Network #1, Primary Vehicle Network (previously SAE J1939
Data Link
|
12
|
Special Instructions
|
Amber Warning Lamp
|
Missing messages from the CAN bus
|
CAN Net Work
|
Loss of CAN Data
|
|
639.14
|
J1939 Network #1, Primary Vehicle Network (previously SAE J1939
Data Link)
|
14
|
Special Instructions
|
Amber Warning Lamp
|
CAN in bus-off. Check wiring and connections.
|
CAN Net Work
|
Loss of CAN Data
|
|
841.07
|
Global Positioning System (GPS)
|
7
|
Mechanical System not Responding or Out of Adjustment
|
Red
|
The GPS receiver controller has lost serial communication with
the Navigation Processor (MPC5200)
|
GPS
|
Communication Lost with GPS Processor
|
|
841.31
|
Global Positioning System (GPS)
|
31
|
Not Available or Condition Exists
|
Amber Warning Lamp
|
Signal interference (from jammer).
|
GPS Position
|
Signal interference (from jammer).
|
|
2850.05
|
Communications Carrier
|
5
|
Not Available or Condition Exists
|
Protect Lamp
|
Reflected antenna power level too high
|
RTK Rover
|
Reflected antenna power
|
|
2854.09
|
Communications Carrier
|
9
|
Not Available or Condition Exists
|
Protect Lamp
|
Corrections age has been exceeded for mobile RTK corrections
|
RTK Rover
|
Corrections age exceeded
|
|
2854.31
|
Communications Carrier
|
31
|
Not Available or Condition Exists
|
Protect Lamp
|
Loss of RTK radio link at Rover
|
RTK Rover
|
Loss of Radio Link
|
|
3141.14
|
GPS Differential Corrections License
|
14
|
Special Instructions
|
Protect Lamp
|
The GPS receiver is not authorized to receive corrections on
the RTK base station.
|
RTK Rover
|
The GPS receiver is not authorized on this RTK network.
|
|
3141.31
|
GPS Differential Corrections License
|
31
|
Not Available or Condition Exists
|
Protect Lamp
|
The GPS corrections license has expired.
|
GPS Corrections
|
The GPS corrections license has expired.
|
|
3144.13
|
Differential Source, Secondary
|
13
|
Out of Calibration
|
Amber Warning Lamp
|
The StarFire receiver cannot link to the StarFire network on
the alternate frequency.
|
SF1/SF2
|
StarFire Signal Not Found
|
|
516198.16
|
Base Station Quality Indicator (BSQI)
|
16
|
Data Valid but Above Normal Operating Range – Moderately
Severe Level
|
Protect Lamp
|
Any of the position standard deviations received from the base
exceed the high threshold.
|
Base position average
|
Bad base position. Check for obstructions or presence of
interfering signal around base receiver.
|
|
522394.13
|
Terrain Compensation Module
|
13
|
Out of Calibration
|
Protect Lamp
|
The TCM has not been calibrated. Run the level calibration
prior to operation.
|
TCM not calibrated
|
The system has detected that the TCM was previously calibrated
on a machine but is now mounted on an implement or has not yet been
calibrated. Please calibrate the TCM to ensure optimized system performance.
|
|
522552.11
|
Navigation Bus 1
|
11
|
Root Cause not Known
|
Protect Lamp
|
The StarFire network has a problem.
|
StarFire Network
|
Problem with StarFire Network. Resolution in Progress.
|
|
523187.02
|
Remote License Activation
|
2
|
Data Erratic, Intermittent or Incorrect
|
Protect Lamp
|
Incorrect license activation received from StarFire satellite.
|
Over-the-Air Messaging
|
Invalid license code received
|
|
523274.02
|
Navigational System Position Data
|
2
|
Data Erratic, Intermittent or Incorrect
|
Protect Lamp
|
GPS position is not available.
|
GPS Position
|
GPS position is not available.
|
|
523310.02
|
Non-Volatile Memory read/write
|
2
|
Data Erratic, Intermittent or Incorrect
|
Amber Warning Lamp
|
StarFire memory error has occurred.
|
Critical Memory
|
Read/Write Failure
|
|
523348.07
|
Inertial Measurement Unit (IMU)
|
7
|
Data Erratic, Intermittent or Incorrect
|
Amber Warning Lamp
|
DTC created from Table 6-6 of 5200-5216 ICD (Value -1: IMU
Communication Failure)
|
TCM
|
TCM Communication Failure
|
|
523348.16
|
Inertial Measurement Unit (IMU)
|
16
|
Data Valid but Above Normal Operating Range - Moderately Severe
Level
|
Protect Lamp
|
The reported temperature from the IMU is outside of its calibrated
range. This can lead to inaccurate pitch, roll, and heading.
|
TCM
|
TCM Temperature out of range
|
|
523348.12
|
Inertial Measurement Unit (IMU)
|
12
|
Bad Intelligent Device or Component
|
Amber Warning Lamp
|
DTC created from Table 6-6 of 5200-5216 ICD (Value -2: IMU
Sensor Failure)
|
TCM
|
TCM Sensor Failure
|
|
523441.31
|
Antenna location (Z axis)
|
31
|
Not Available or Condition Exists
|
None
|
The GPS antenna height not set.
|
TCM
|
StarFire Height Dimension Not Set, press setup tab on main page
|
|
523442.31
|
Antenna location (X axis)
|
31
|
Not Available or Condition Exists
|
None
|
The GPS fore-aft dimension not set.
|
TCM
|
StarFire Fore/Aft Dimension Not Set, Press setup tab on main
page
|
|
523773.03
|
CAN High line
|
3
|
Voltage Above Normal or Shorted to High Source
|
None
|
The StarFire CAN HI voltage is too high. Check wiring.
|
CAN HI Voltage Too High
|
|
|
523773.04
|
CAN High line
|
4
|
Voltage Below Normal or Shorted to Low Source
|
None
|
StarFire CAN HI voltage is too low. Check wiring.
|
CAN HI voltage is too low
|
|
|
523774.03
|
CAN Low line
|
3
|
Voltage Above Normal or Shorted to High Source
|
None
|
The StarFire CAN LO voltage is too high. Check wiring.
|
CAN LO voltage is too high
|
|
|
523774.04
|
CAN Low line
|
4
|
Voltage Below Normal or Shorted to Low Source
|
None
|
The StarFire CAN LO voltage is too low. Check wiring.
|
CAN LO voltage is too low
|
|
|
524209.16
|
RTK Rover relative distance
|
16
|
Data Valid but Above Normal Operating Range - Moderately Severe
Level
|
Protect Lamp
|
The RTK rover is too far from the base station for the corrections
to be valid.
|
RTK Rover
|
Vehicle too far from Base Station
|
|
524257.14
|
RTK base station location
|
14
|
Special Instructions
|
Protect Lamp
|
The RTK base station is in survey mode. Corrections are unavailable.
|
RTK Base Station
|
The RTK base station is in survey mode. Corrections are not
available.
|
|
524257.16
|
RTK base station location
|
16
|
Data Valid but Above Normal Operating Range - Moderately Severe
Level
|
Protect Lamp
|
The RTK base station has been moved. Corrections are not valid.
|
RTK Base Station
|
Base Station has been Moved
|
|
524257.19
|
RTK base station location
|
19
|
Received Network Data in Error
|
Protect Lamp
|
Multiple RTK Base Stations Detected
|
RTK system
|
Interference between neighboring RTK base stations. Adjust
your RTK Network settings to unique values.
|