Calibrate Implement Steering (Implement Steering Only)

CAUTION: Implement moves during calibration. Verify that people and obstructions are clear of immediate area during all procedures. Read and follow Operate Implement Automation Systems Safely in Safety section before performing calibration.

NOTE: Implement Steering Calibration is not needed when operating Implement Shifting.

PC14926-UN-27APR12

Application Controller 1100 Button

PC13072-UN-16NOV10

Application Controller Main Softkey

PC17975-UN-07NOV13

Implement Steer Setup Button

PC17976-UN-07NOV13

Wheel Angle Setup Button

PC17977-UN-07NOV13

Set Max Right Position Button

PC17978-UN-07NOV13

Set Max Left Position Button

PC17979-UN-07NOV13

Set Center Position Button

1. Select Application Controller 1100 button.

2. Select Application Controller Main softkey.

3. Select Implement Steer Setup.

   NOTE: Depending on steering system, it may be necessary to drive forward slowly during wheel angle sensor calibration.

4. Select Wheel Angle Setup.

5. Engage SCV to set implement steering to full right position. Hold SCV lever, and select Set Max Right Position.

6. Engage SCV to set implement steering to full left position. Hold SCV lever, and select Set Max Left Position.

7. NOTE: Center position is critical to accurate line acquisition and operation. It may be necessary to drive machine and implement forward before setting position.

   Engage SCV to center implement steering mechanism. Verify steering mechanism causes implement to follow perpendicular to machine rear axle. Select Center Position. A correct center position should results in an off track error of zero.

Center Calibration Position Verification

To verify center position calibration, engage Active Implement Guidance. When error reads zero, select Set Center Position to verify that center position is correct.