Daily Checklist

□  Inspect wiring harness for wear and damage around pinch points, corners, edges, and harness support locations. Repair as necessary.

□  Inspect wiring harness at connectors for wear on exposed wires. Repair as necessary.

□  Inspect mounting hardware. Retorque as necessary.

□  Display

□  Controller mount

□  Run control unit diagnostic tests.

□  Perform Control Valve test.

□  Verify section status readings.

□  Verify system voltage readings.

□  Verify switches and status readings.

□  Verify sensor and status readings.

(Reference implement Operator’s Manual for detailed checklists.)

When changing product, empty bin or tank, perform rinse cycle, and perform new product setup and calibration.

Some tests are not available depending on application.