Set Up Implement Height Indicator

Implement height switch is required for NH3 applications and cannot be disabled.

Implement height indicator is optional for liquid fertilizer tools (switch only) and air carts (switch or sensor). Implement height indicator can be enabled, disabled, and set up without the setup wizard for these applications.

1. 
   PC22295-UN-21MAR16

   John Deere Rate Controller 2000 Button

   Select the John Deere Rate Controller 2000 button.

---




2. 
   PC22296-UN-21MAR16

   Setup Softkey

   Select the Setup softkey.

---




3. 
   PC22693-UN-25MAY16

   A - Implement Tab

   B - Height Indicator Checkbox

   C - Height Setup Button

   Select the Implement tab (A).

---




4. To enable, select the Implement Height Switch or Height Indicator checkbox (B).

5. To change the type of the height indicator, select the Height Setup button (C).

6. 
   PC22694-UN-09JUN16

   
   PC22695-UN-09JUN16

   A - Height Indicator Drop-Down Menu

   B - Current Voltage

   C - New Set Point

   D - Accept Button

   Select Sensor or Switch from the Height Indicator drop-down menu (A).

   If Sensor is selected, lower implement to the ground and enter the Current Voltage (B) into New Set Point (C).

---




7. Select the Accept button (D).