Detach 120R Loader

W14000
W14000-UN-05OCT88

Prevent possible injury caused by a falling or shifting loader. Always detach the loader on a hard, level surface. DO NOT detach the loader if equipped with a pallet fork. A materials bucket is recommended.

  1. W27181
    W27181-UN-10DEC15

    Avoid damage to hydraulic hoses. Make sure that the hoses are removed from retaining guides before detaching the loader. Avoid damage to the machine. Remove fender extensions before detaching the loader.

    Start the engine.


  2. Release the park brake or place the transmission in NEUTRAL.

  3. Dump the bucket 10—20° and lower to the ground.

  4. Retract lift cylinders, raising the front wheels 25—50 mm (1—2 in) off the ground.

  5. W27139
    W27139-UN-02DEC15

    Right-Hand Side Shown

    A - Latch (1 each side)

    Move both mast latches (A) upward into the UNLOCKED position.


  6. Avoid damaging hydraulic hoses. Remove the hose bundle from the hose guide so that the hoses DO NOT get pinned on top of the mast during detaching.

    W22989
    W22989-UN-10SEP12

    A - Hose Bundle

    B - Hose Guide

    Remove the hose bundle (A) from the hose guide (B).


  7. W27182
    W27182-UN-10DEC15

    A - Mast

    B - Parking Stand

    C - Mounting Frame

    D - Latch

    Roll back the bucket level to the ground. Extend lift cylinders until the parking stand (B) contacts the ground, masts (A) lifts off mounting frames (C), latches (D) automatically snap into the locked position.


  8. Engage the park brake or place the transmission in PARK.

  9. Shut off the engine.

  10. The loader and implements can shift when the hydraulic pressure is relieved.

    Relieve the hydraulic pressure. (See Relieve Hydraulic Pressure in Controls section.)

  11. W21472
    W21472-UN-18FEB11

    1R Series Tractor Shown

    A - Coupler, Female (4 used)

    B - Coupler, Male (4 used)

    C - Plug (4 used)

    D - Cap (4 used)

    Disconnect hydraulics:

    1. Push back the collar on the female coupler (A) and pull out the male coupler (B).

    2. Install the dust plug (C) in the female coupler and the cap (D) on the male coupler as shown.

    3. Repeat for all the remaining hose connections.

    4. Store the hoses on the boom. Do not lay the hoses on the ground.


  12. W27183
    W27183-UN-10DEC15

    Avoid hydraulic hose damage. Be sure that the hoses DO NOT catch on the tractor when moving away from the loader.

    Start the engine.


  13. Disengage the park brake or place the transmission in REVERSE. Pull away from the loader.

OUO6064,000174A-19-20180829