To the Dealer

W27694
W27694-UN-30NOV16

Right-Hand Side Shown

W22174
W22174-UN-14FEB12

(A) (Both Booms and Torque Tube)

Ensure decal adhesion. Before applying the new decals, clean all dirt, grease, oil, and moisture, and decal remover (if used) from the application area. Surface temperature must be greater than 15°C (60°F) for best adhesion.

Use images to identify the decal locations. Perform these steps for each decal replacement:

  1. Remove the paper backing from the new decal.
  2. Align the decal and press one edge of the new decal onto the loader.
  3. Smooth out the air pockets while slowly pressing across the decal to the opposite edge. Ensure complete decal adhesion.

Hoist point decals (A) are required for European CEN countries, but are optional for all other countries.

Inspect the condition of the hoist decals (A), replace as necessary in locations shown.

OUO6064,000199C-19-20180529