Check Tyre Inflation Pressure

Check tyres daily for damage or noticeably low pressure.

At least every 100 hours of operation, check inflation pressure with a gauge. Use an accurate gauge having 10 kPa (0.1 bar) (1 psi) graduations.

If tyres contain liquid ballast, use a special air-water gauge and measure with valve stem at bottom.

NOTE: When furrow plowing or during hillside operation, tyre pressure can be increased 28 kPa (0.28 bar) (4 psi) ABOVE maximum to prevent tyre wrinkling or buckling.

1. IMPORTANT: Always check inflation pressure with an accurate tyre gauge to prevent over-inflation. Over-inflation reduces performance and increases strain of both tyre and rim.

   NOTE: Following inflation information applies to both front and rear tyres and Tyre Inflation Pressure Chart.

   All inflation pressures are calculated for 29 km/h (18 mph) travel speeds for both diagonal (bias) ply and radial ply tyres.

2. Operation of tyres at the inflation pressures listed on chart will result in optimum tractive performance of the tyre/vehicle system. Correctly inflated radial tyres will show a large deflection of the sidewall or “cheeks”. This is normal and will not hurt the tyre if the inflation pressure is maintained.

3. Inflation pressures less than 80 kPa (12 psi) should be monitored regularly because of the increased risk of low pressure air leaks (especially due to leaking valve cores).

4. Tractors operating on steep side slopes should increase inflation pressures 28 kPa (4 psi) above the values listed to compensate for lateral weight transfer.

5. Tyres run as singles in high traction conditions sometimes experience bead slip if the bead was not fully seated or if too much lubricant was used to mount the tyre. Increasing the inflation pressure will compensate for this condition but will not cause reduced traction. Consult your tyre dealer if this problem occurs.

6. If higher load capacities are needed, contact your John Deere dealer for tyre manufacturers load and inflation table information.