Change Transmission-Hydraulic Oil and Filter

1. Lower rockshaft to remove trapped oil.

NOTE: The approximate transmission case oil capacity is 38 L (10 gal)

2. Remove drain plug (C) from transmission case (A) and drain out oil.

3. Replace filter (B) while changing oil. Apply a film of oil to new filter gasket and install new filter. Hand tighten only.

4. Fill system with transmission-hydraulic oil. (See Fuels, Lubricants and Coolant section.)

Specification

Transmission Oil -Capacity 38 L (10 gal)

5. Check oil level at dipstick (D) after filling, and again after operating for five minutes.


A-Transmission Case
B-Filter
C-Drain Plug
D-Dipstick

PY4417
PY4944

PY80265,05G1343 -19-12SEP05-1/1