Adjusting Hitch Side Sway

NOTE: Check implement operator's manual for instruction on whether to allow side sway.

If sway is desired, install pin (A) in an outer sway bar (F) sway position hole (C), ensuring it goes through slot (D) of inner sway bar (G).

If sway is not desired, move draft link (E) to desired position. Install pin in an outer sway bar fixed position hole (B) that lines up with one of the five inner sway bar fixed position holes.

Adjust sway bars on other side of tractor to the same position.

A-Pin
B-Fixed Position Hole (5 used)
C-Sway Position Hole
D-Slot
E-Draft Link
F-Outer Sway Bar
G-Inner Sway Bar

OUO1043,000027F -19-18JAN01-1/1