Operating PowrReverser™ Transmission

CAUTION: Always place transmission gear shift lever in park position and Electro-Hydraulic Directional Reverser lever in neutral before dismounting. Leaving transmission in gear with engine stopped WILL NOT prevent tractor from moving.

Gear shift lever (A) provides four travel speeds (1, 2, 3, 4), in forward and reverse.

Range shift lever (B) provides three speed ranges (A, B, C).

ELECTRO-HYDRAULIC (EH) directional reverser lever (C) provides travel direction (forward or reverse).

IMPORTANT: To prevent unnecessary wear, never "ride" the clutch by resting a foot on the pedal.

NOTE: EH directional reverser lever must be in neutral for engine to start.

CAUTION: Never start engine while standing on ground. Start engine only from operator's seat, with transmission in neutral or park.

1. At tractor start-up, the operator must be in the tractor seat before the EH directional reverser lever will recognize directional command.

2. Depress clutch pedal and stop tractor before shifting range shift lever.

3. Use EH directional reverser lever to select travel direction. Changing travel direction is done without depressing clutch pedal.

4. Depress clutch pedal when shifting gears. Gear shifts (1, 2, 3, 4) can be made on-the-go, without stopping. Release clutch pedal gradually to take up load smoothly.

A-Gear Shift Lever
B-Range Shift Lever
C-EH Directional Reverser Lever

OUO1023,00027AB -19-15FEB06-1/2

Using range and gear shift levers in different combinations, twelve forward and reverse speeds are available. See GROUND SPEED ESTIMATES-PowrReverser™ TRANSMISSION for range, gear settings and corresponding speeds.

OUO1023,00027AB -19-15FEB06-2/2