Service Daily Before Start-Up

IMPORTANT: For models 5425, 5525 and 5625, during the first 100 hours of operation, fill with John Deere Diesel Engine Break-In Oil.

1. Check engine oil level. Wipe dipstick (A) off and reinsert it fully. Remove and locate oil level. Do not operate when oil level is below lower mark on dipstick. Add seasonal viscosity grade oil through filler hole (B).

2. If operating in extremely wet or muddy conditions, lubricate with multipurpose grease the following at the 10-hour service interval:

  • Front axle pivot pin
  • Steering spindles and cylinder ends (adjustable front axle)
  • King pins (MFWD)
  • Rear axle bearings

3. Lubricate with multipurpose grease. (If necessary, clean first with a pressure washer):

  • Hood latch
  • Operator's seat slide rails (Straddle Mount, Hi-Crop and IOOS)
LV9602

5225 and 5325

LV9603

5225 and 5325

LV9601

5425, 5525 and 5625


A-Engine Oil Dipstick
B-Engine Oil Filler Cap

OUO1023,00028AB -19-15SEP06-1/1