Using Mechanical Rockshaft Position Control

CAUTION: Prevent unexpected movement of rockshaft. Put draft control lever (B) in full forward position before attaching implement.

Push draft control lever (B) fully forward when you DO NOT want rockshaft to adjust automatically to draft load, such as when attaching an implement to the tractor.

Use position control lever (A) to control hitch movement and depth:

For transport of implements and end of field turn-around, pull control lever (A) fully rearward for both load and non-load sensing usage.

A-Position Control Lever
B-Draft Control Lever
C-Control Lever Stop

OUO1023,00029C0 -19-17OCT06-1/3

1. For constant depth of implements on level terrain and for non-ground engaging implements such as spreaders or sprayers, put position control lever (A) at desired depth.
2. Operate implement for a few minutes to determine proper depth or height.
3. Lift tab and slide stop against position control lever. Turn tab to tighten and press down to lock stop in place. Rockshaft will return to the same position each time control lever contacts the stop.

OUO1023,00029C0 -19-17OCT06-2/3

For float operation for implements with skids or depth gauge wheels designed to carry full implement weight, push both position and draft control levers (A and B) all the way forward, so implement can follow ground contour.

NOTE: Lift links can be adjusted for lateral float. (See Adjusting Lateral Float in Section 65.)

OUO1023,00029C0 -19-17OCT06-3/3