Using Rear SCV to Operate Hydraulic MotorDeluxe Valve Section I OnlyIMPORTANT: Use SCV I (A), with adjustable (internal) flow control valve (B) for hydraulic motor operations. Never regulate SCV I oil flow with an external flow control valve. Having two flow control valves in the same hydraulic circuit can overheat oil causing component malfunctions and damage. Basic Valves and Deluxe Valve Sections II or IIIUse external flow control valve to regulate oil flow when operating a hydraulic motor with any basic valve or deluxe valve sections II or III, without internal flow control.
|
|
OUO1023,00029C4 -19-17OCT06-1/2 |
|
Hydraulic Motor Hose Connections and Control Lever Operations
1. Shut off engine. 2. Move SCV control lever full forward, into "float" detent. With deluxe valve, use SCV I control lever (A). 3. Connect hydraulic motor hoses to SCV couplers that correspond to selected control lever. With deluxe valve, use SCV I couplers. 4. Deluxe Valve: Set control lever detent for continuous "motor" operation. See Setting Detents and Operating SCV Control Levers-Deluxe Valve-If Equipped in this section. 5. Start engine. 6. To activate hydraulic motor, move control lever back to "retract" position. IMPORTANT: Do not use "neutral" lever position to stop hydraulic motor; use "float". Neutral standby pressure may cause back-pressure damage to hydraulic motor or hoses. 7. To stop hydraulic motor, move control lever full forward into "float" detent. 8. Shut off engine and disconnect hoses from couplers. |
|
OUO1023,00029C4 -19-17OCT06-2/2 |