Adjusting Load/Depth EH Controls-If Equipped

causym CAUTION: Before connecting implement to 3-point hitch, prevent unintentional raising or lowering of the rockshaft by turning load/depth control knob (A) to detent position (B).

Hitch has two operating modes:

  • Detent control position (B)
  • Draft control positions (C)

Position Control Setting

With load/depth knob in detent control position (B), the implement is held at the selected position.


A-Load/Depth Control
B-Position Control Detent
C-Draft Control Settings

LV12567
LX1026119

OUO1032,00016B8 -19-13APR05-1/2

Using Draft Control

Turn load/depth knob to one of five draft settings (C), to control depth and load, depending on implement and field or soil conditions:

  • Turn COUNTERCLOCKWISE to reduce draft response.
  • Turn CLOCKWISE to increase draft response.

With the control turned to a higher number, the implement is raised as resistance (soil density) increases and lowered as resistance decreases; typical settings:

Implement Draft Control Setting
Integral Ripper/Subsoiler 1-3
Integral Chisel Plow 2-4
Semi-Integral Moldboard Plow 2-4
Integral Moldboard Plow 3-5
Integral Field Cultivator 4-5

 
LX1026120

Low-to-Mid Settings

LX1026059

Mid-to-High Settings

OUO1032,00016B8 -19-13APR05-2/2