Using Mechanical Draft Control-If Equipped
The rockshaft is equipped with variable draft control system:
-
Operating with a fully mounted implement in hill and swale terrain, the implement will rise and lower to follow the ground contours while maintaining a nearly constant depth.
-
Operating in varying soil conditions, the implement is raised slightly to get through tough spots so you do not have to shift to a lower gear.
Change draft sensitivity ranges by repositioning the center link.
For draft load sensing operation:
1.
Pull control lever (A) to its fully rearward position and push the draft control lever (B) to the fully forward (least draft) position.
2.
With tractor moving, push control lever (A) forward to set implement operating depth.
3.
Set position control lever stop (C). The operating depth set up will prevent the rockshaft from lowering all the way when the tractor begins to slip.
4.
Pull draft sensing lever (B) rearward until desired draft sensing sensitivity is obtained.
5.
To slightly raise implement (for getting through slippery spots in a field), push control lever (A) past the draft control setting.
6.
Pull control lever (A) fully rearward to raise the hitch at the end of the field.
A-Position Control Lever
B-Draft Control Lever
C-Position Control Lever Stop
|
