Pack Front Wheel Bearing (2WD)

1. Loosen front wheel cap screw.

2. Jack up front end of tractor.

causym CAUTION: Support tractor securely on stands before removing a wheel.

3. Remove wheel.

4. Remove cover (A), cotter pin (C) and nut (B) to remove wheel hub (E).

5. Pack inner bearing (F) and outer bearing (D) with multipurpose grease. (See Fuels, Lubricants and Coolant section.)

6. Install hub assembly and retaining nut. Tighten nut until a slight drag is felt while turning hub. Back off nut just enough to install cotter pin in hole of spindle.

7. Apply flexible sealant to mating surface of cover (A) and hub (E). Install cover.

8. Install hub cap and wheels. Tighten lug bolts to specification. Tighten bolts again after driving tractor 100 m (109 yd) and again after three hours and 10 hours use.

Specification

Adjustable Front Axle Lug Bolts -Torque 175 N·m (130 lb-ft)

LV8746


A-Cover
B-Retaining Nut
C-Cotter Pin
D-Outer Bearing
E-Wheel Hub
F-Inner Bearing

AH98466,0000976 -19-15JUL08-1/1