Joystick Function (If Equipped)
The Control lever or the SCV I and SCV II has four directions of movement to enable simultaneous controls of two functions.
Forward and back direction (A) has the following positions:
-
Pulled fully rearward- Extend position
SCV I is normally connected to the loader boom
cylinder and raises when the lever is pulled rearward.
-
Spring centered-Off and lock position
SCVs are locked to hold the boom and bucket in
position.
-
Pushed slightly forward-Retract position
Boom cylinder is lowered, valve can be metered to
control rate of lowering.
-
Pushed fully forward-Float position
SCV connects both cylinder ports to the return circuit.
Loader boom can move freely to follow ground contour.
Lever must be manually returned to neutral.
Inward and outward direction (B) has the following position :
-
Pushed slightly outward-Extend position
SCV II is normally Connected to the bucket cylinder and
dumps when the lever is moved to the right.
-
Pushed fully outward-Regenrative
position Provides faster loader bucket dump. Reduces cavitation.
Lever returned to neutral by valve spring
-
Pulled inward-Retract position.
Flow to the bucket cylinder can be metered to slowly
roll the bucket upward.
TRANSPORT LOCK
Loader control lever has a transport lock (C). Pull the transport lock lever upwards to lock the lever and push it downwards to unlock.
|
Mid SCV Control Joystick
A-Forward and Backward Direction
B-Inward and Rearward Direction
C-Transport Lock
|
