Ballast Front End for Transport

causym CAUTION: Additional front ballast may be needed for transporting rear-mounted implements. When implement is raised, drive slowly over rough ground, regardless of how much ballast is used.

causym CAUTION: Weights are heavy. Use proper lifting equipment. Approximate weight of starter weight (C) is : 49 kg (109 lb). Approximate weight of QUIK-TATCH ™ weights (D) are 45 kg (99 lb).

Specification

Starter Weight (Ballast) -Weight 50 kg (110 lb) Each
QUIK-TATCH™ Weight (Ballast) -Weight 45 kg (99 lb) Each

Installing QUIK-TATCH ™ Weights: QUIK-TATCH™ weights can be installed on the front of the tractor.

One starter weight and up to eight QUIK-TATCH ™ weights can be installed.

1. Install weights in pairs, one on each side of center (A).

2. To hold weights in place, run retaining bolts (B) through holes from side-to-side. Tighten to specification.

Specification

Ballast Weights Retaining Bolts -Torque  230 N·m (170 lb-ft)
Starter Weight Bolts -Torque 385 N·m (284 lb-ft)

PY8029


A-Ballast Center
B-Ballast Retaining Bolts
C-Starter Weight
D-QUIK-TATCH Weights

QUIK-TATCH is a trademark of Deere & Company

SA61034,0000238 -19-29FEB08-1/1