Change Transmission-Hydraulic Oil and Filter (For 5045D and 5055D Tractors)

1. Lower rockshaft to remove trapped oil.

2. Remove drain plug (C) from transmission case and drain oil. Dispose of waste oil properly.

3. Replace filter (B) while changing oil. Apply a film of oil to new filter gasket and install new filter. Hand tighten only.


A-Axle Housing
B-Transmission Oil Filter
C-Transmission Case Drain Plug

PY4417

SA61034,0000259 -19-24SEP08-1/2

4. Fill system with transmission-hydraulic oil. (See Fuels, Lubricants and Coolant section.)

Specification

Transmission Oil (Rear tyre size: 13.6 X 28) -Capacity 33 L 
Transmission Oil (Rear tyre Size: 14.9 X 28 -Capacity 34 L 

5. Check oil level at sight glass after filling. Make sure oil level is to full level mark (A). Check again after operating for five minutes. Add oil if necessary.


A-Full Level Mark
B-Add Level Mark

PY7351

SA61034,0000259 -19-24SEP08-2/2