Clean Transmission-Hydraulic Pickup Screen

1. Drain transmission-hydraulic oil. (See Change Transmission-Hydraulic Oil and Filter in this section.)

NOTE: The approximate transmission case oil capacity is 38 L (10 gal) for 2-WD tractors and 39 L (10.30 gal) for MFWD tractors.

2. Remove two cap screws (A) and remove screen cover (B).

3. Remove screen and examine it for damage. Replace if necessary. Clean screen in solvent and blow dry with compressed air.

4. Carefully install screen so the front of screen is inserted in hole at front of differential case.

5. Fill system with transmission-hydraulic oil. (See Change Transmission-Hydraulic Oil and Filter in this section.)


A-Cap Screws
B-Screen Cover

PY7315

For 5045E, 5055E, 5065E and 5075E Tractors

PY4974

For 5045D and 5055D Tractors

SA61034,000025A -19-24SEP08-1/2

6. Check oil level at dipstick (C) after filling, and again after operating for five minutes.


C-Transmission-Hydraulic Oil Dipstick

PY4447

SA61034,000025A -19-24SEP08-2/2