Change Transmission-Hydraulic Oil and Filter

A-Cap Screws (2 used)
B-Plate
C-Filter
D-Seal
E-Spring
F-O-Ring
G-Oil Dipstick

2. Remove cap screw (A) and plate (B).

3. Remove filter (C) and replace with new filter.

4. While assembling filter check position of seal (D) spring (E) and O-ring (F).

5. Assemble filter in reverse order.

6. Install drain plug

7. Fill system with transmission-hydraulic oil. (See Fuels, Lubricants and Coolants section.)

8. Check oil level at dipstick (G) after filling, and again after operating for 5 minutes.

NR25796,0000F3F -19-02MAY08-1/1