Service Daily Before Start-Up

1. Check engine oil level. (See CHECK ENGINE OIL LEVEL in Lubrication section.)

2. Check hydraulic oil level through sight glass. (See CHECK TRANSMISSION/HYDRAULIC SYSTEM OIL LEVEL in Lubrication section.)

3. Drain water and sediment from fuel filters. (See procedure in Maintenance—Fuel System section.)

4. Check level in coolant overflow reservoir. (See CHECK COOLANT LEVEL in Maintenance—Cooling System section.)

5. IMPORTANT: If operating in extremely wet or muddy conditions, lubricate several additional components daily.

   If operating in extremely wet or muddy conditions, lubricate the following at 10-hour service intervals (See procedures in Lubrication section):

   • Front axle pivot pin
   • Steering linkage
   • MFWD shaft
   • Front wheel bearings (2WD)
   • Rear axle bearings
   • Hood latch