Insufficient transport clearance
Adjust center link
Lift links too long
Adjust lift links
Implement not level
Level implement
Implement not properly adjusted
See implement operator's manual
Sway chains adjusted too short
Lengthen sway chains
Hitch drops slowly
Adjust rate-of-drop control knob
Hitch fails to lift or lifts slowly
Reduce load
Low oil level
Fill system with proper oil
Hydraulic oil too cold
Allow oil to warm
Transmission/hydraulic oil filter clogged
Replace filter
Implement will not operate at desired depth
Lack of penetration
Improper setting of limit stop
Reset limit stop
Improper setting of draft control lever
See Rockshaft and 3-Point Hitch section
Insufficient or no hitch response to draft load
Pull knob upward
Lift links too short
Rate-of-drop too slow
Hitch too responsive
Push knob down
Hitch drops too fast
OUO6070,00000A9-19-20080123