Requirements for E-SCVs

Before transferring control to implement, prepare implement as indicated in implement Operator's Manual. Transfer control using AutoTrac™ resume switch or TIA resume softkey as presented in implement Operator's Manual.

The following guidelines must be met before transferring implement control.

• Operator sitting on seat.
• SCVs are functional.
• SCV control levers in neutral position.
• SCVs are not locked (transport lock).
• SCV flow limit set by operator

NOTE: Using tractor's CommandCenter, operator sets SCV flow limit which cannot be exceeded by implement.

While operating, implement has ability to:

• Control SCVs during operations.
• Change SCV flow rate up to operator set limit.

To withdraw control:

• Actuate specific SCV lever.
• Lock SCVs (transport lock).
• Actuate remote control switch on fender.

NOTE: Unless implement is authorized to adjust SCV flow when tractor is stationary, tractor will prevent SCV flow adjustments when stationary. Implement is however, allowed to stop oil flow.