Hitch Control Center (HCC) Diagnostic Trouble Codes
Although the diagnostic codes listed below are not a complete
list of the diagnostic trouble codes, they do reflect codes which
may be observed while operating the tractor and have corrective action
that the operator can take. Many codes which appear may be corrected
simply by cycling key switch or by following the solution on the CommandCenter page,
then cycling key switch.
If corrective action cannot be taken after cycling power to
the tractor or if there are any questions, contact your John Deere dealer.
|
Hitch Control Center (HCC) Diagnostic Trouble
Codes
|
|
Diagnostic Trouble Code
|
Display
|
Solution
|
|
HCC 158.4
|
Rear Hitch System
|
Reduce electrical load or increase engine RPM to attempt vehicle
system recovery.
|
|
HCC 168.4
|
Electrical System
|
Reduce electrical load or increase engine RPM. Shut down the
engine and check fuse. Restart engine to attempt vehicle system recovery.
|
|
HCC 2602.18
|
Hydraulic System
|
Limit hydraulic use to allow oil reservoir to refill. Check
oil level according to Operator's Manual procedure.
|
|
HCC 523788.14
|
Rear Hitch System
|
Reference Hydraulic Option Configuration procedure in Operator's
Manual.
|
|
HCC 523788.2
|
Rear Hitch System
|
Reference Hydraulic Option Configuration procedure in Operator's
Manual.
|
|
HCC 523952.31
|
Rear Hitch Disabled
|
Rear hitch not enabled or available.
|
|
HCC 524016.4
|
Rear Hitch System
|
Reduce electrical load or increase engine RPM. Shut down the
engine and check fuse. Restart engine to attempt vehicle system recovery.
|
|
CommandCenter
is a trademark of Deere & Company
John Deere
is a trademark of Deere & Company
|
OURX935,0001103-19-20100517
|
|