Handling HID Light Bulbs Safely

CAUTION:

TS266-UN-23AUG88

• High voltage is conducted by electrical connection between worklights and ballast unit; this connection must never be disconnected without first disconnecting vehicle wiring harness to ballast.
• Handle bulb by its base. Keep bulb oil free; wear gloves to avoid touching glass. Use a clean cloth and alcohol to remove any fingerprints from the glass bulb before installing. Skin oil deposited on bulb will cause overheating and premature failure.
• Do not operate bulb outside of enclosure. When operating, HID bulbs have high internal pressure and if they are cracked or broken, they could explode and cause injury.
• Turn light switch off and allow bulbs to cool before changing. Leave switch off until bulb change is done.
• Wear eye protection.
• Do not drop or scratch bulb. Keep moisture away.
• Place used bulb in the new bulb carton and dispose of properly. Keep out of reach of children.