Insufficient transport clearance
Adjust center link
Center link in wrong position
Put center link of tractor in correct hole. See Hitch section.
Lift links too short
Adjust lift links
Implement not level
Level implement
Implement not correctly adjusted
See implement operator’s manual
Upper height limit not correctly set
Adjust upper height limit in CommandCenter™
Hitch fails to follow lever
See your John Deere™ dealer
Poor position control
System is reset
Enable system
Malfunction in lever position sensor circuit or hitch position sensor
Hitch drops slowly
Adjust rate-of-drop in CommandCenter™
Hitch fails to lift or lifts slowly
Reduce load
Hitch valve leak
Raise limit switch setting may be limiting lift
Check settings in CommandCenter™
Implement will not operate at desired depth
Lack of penetration
Draft sensor failed
Insufficient or no hitch response to draft load
Adjust load/depth mix in CommandCenter™
Rate-of-drop too slow
Hitch too responsive
Hitch settles too fast after tractor is parked and engine shut off
Hitch will not move (controls not working, including rear raise/lower switches)
Replace fuses
External raise/lower switches will not move hitch
Lever in transport lock
Move lever out of transport. Unlock hitch at CommandCenter™
ZE59858,0000568-19-20101108