Requirements For Rear Hitch

Before transferring control to implement, prepare implement as indicated in implement Operator's Manual. Transfer control using AutoTrac resume switch or TIA resume softkey as presented in the implement Operator's Manual.

Implement can automatically control hitch depth.

The following preconditions have to be met before transferring implement control.

NOTE: Operator sets raise limit using tractor CommandCenter. This limit cannot be exceeded by implement.

The following preconditions must be met:

• Operator sitting in seat.
• Hitch must be functional.
• Hitch control lever in neutral position.
• Hitch is not locked.

While operating, implement has the ability to control hitch depth.

To withdraw control:

• Actuate hitch control lever.
• Lock hitch (transport lock.)
• Actuate fender switch (if equipped).

NOTE: Unless the implement is authorized to adjust hitch depth when the tractor is stationary, the tractor will prevent hitch depth adjustments when stationary.