500 Hour Service Records

• Changing engine oil and filter NOTE: R Series Tractors are equipped with either IT4/Stage IIIB or Tier 2/Stage II engine. See Record Engine Serial Number in Identification Numbers section to determine which engine is applicable.

  The initial break-in service interval of a new or rebuilt wet sleeve engine with Break-In Plus must go at least 100 hours to assure the surface mating of the rings and liners has had an opportunity to occur. The 100 hour minimum applies to all new or rebuilt engines. The maximum service interval is the same as the service interval recommendations listed in Engine Oil and Filter Service Intervals locted in section 90 of this Operator's Manual.

  
  
• Replacing BOTH fuel filters¹
• Cleaning optional fuel water separator filter element (If Equipped)
• Checking wheel and wheel weight bolts
• Checking dual beam radar sensor
• Checking air intake system
• Lubricating front PTO drive shaft

Hours					Hours
Date					Date
Hours					Hours
Date					Date
Hours					Hours
Date					Date
Hours					Hours
Date					Date