Towing Loads
CAUTION: Avoid possible injury from losing control while towing
a load. Stopping distance increases with speed and weight of towed
loads, and on slopes. Tractor wheels may lock and skid
on slippery downhill slopes on tractors equipped withAutoPowr transmission.
(See Downhill Operation In Slippery Conditions, in Operating AutoPowr
Transmission section.)
Never transport at speeds exceeding the implement's maximum
transport speed. Before transporting a towed implement, refer to the
implement operator's manual and implement decals to determine the
maximum transport speed. This tractor is capable of operating at transport
speeds exceeding the maximum allowable transport speed for most towed
implements. Use implement code in implement operator's manual to determine
the minimum number of front weights required. Failure to adhere to
the implement's maximum transport speed or to have correct ballast
can result in:
-
Loss of control of the tractor/implement combination
-
Reduced or no ability to stop during braking
-
Implement tire failure
-
Damage to the implement structure or components
Guidelines for Towing Equipment without Brakes:
-
Do not transport at speeds greater than 32
km/h (20 mph).
-
Must weigh less than 1.5 times the tractor
weight or less than 1.5 t (3300 lb) when fully loaded.
Guidelines for Towing Equipment with Brakes:
-
If manufacturer does not specify a maximum
transport speed, do not transport at speeds above 40 km/h (25 mph).
-
When transporting at speeds up to 40 km/h
(25 mph) the fully loaded implement must weigh less than 4.5 times
the tractor weight.
-
When transporting at speeds between 40 km/h
(25 mph) to 50 km/h (31 mph), the fully loaded implement must weigh
less than 3 times the tractor weight.
The tractor must be heavy and powerful enough with adequate
braking power for the towed load. Add ballast to tractor or lighten
the implement load.
Drive slowly enough to maintain safe control. Be alert for skids.
Shift to a lower gear for hillsides, rough ground, and sharp turns,
especially when transporting heavy equipment.
Never operate with transmission in neutral position or with
clutch disengaged.
|
AutoPowr is a
trademark of Deere & Company
|
OURX935,0000AD7-19-20090825
|
|