Break-In Checks

Tighten wheel and axle bolts after 3 HOURS, 10 HOURS and daily for the first week of operation.

Operate engine at heavy loads without sustained maximum load.

Avoid idling engine longer than 5 minutes.

Daily or Every 10 Hours

IMPORTANT: John Deere Break-in Oil must be added if oil level is BELOW ADD MARK on dipstick. DO NOT fill above crosshatch pattern or FULL mark.

• Check engine oil level
• Check coolant level
• Check transmission-hydraulic oil level
• Lubricate front axle:¹
  • Standard front axle: Pivot pin, wheel bearings, steering spindles/cylinder ends and tie rod ends¹
  • MFWD: Axle pivot, king pins and tie rods¹
• Lubricate hitch components
• Inspect tires to make sure tires have no cuts or punctures
• Drain moisture from the trailer brake air pressure tank (if equipped)