500 Hour Service Records

• Change engine oil and filter *
• Tighten wheel and weight bolts**
• Inspect drawbar support (tighten cap screws-if needed)
• Clean dual beam radar sensor
• Replace fuel filters ***
• Inspect air intake system for loose clamps and worn hoses
• Check drawbar bolts
• Clean water separator (optional severe duty)
• Lubricate rear hitch draft sensor

Hours					Hours
Date					Date
Hours					Hours
Date					Date
Hours					Hours
Date					Date
Hours					Hours
Date					Date

* SCHEDULED oil and filter change interval is only allowed if using diesel fuel with sulfur content less than 15 mg/kg (15 ppm), John Deere™Plus50 ™ II oil and John Deere filter are used. If above conditions are not met, change oil and filter at 250 hours of operation, or even if all the conditions are met, change oil and filter at least once every 12 months even if hours of operation are less than the otherwise recommended service interval.

** INITIAL tighten at 3 and 10 hours, and daily for first week of operation.

*** Interval can vary according to operating conditions.