Engine Oil and Filter Service Intervals—Tractors With 13.5 L Tier 2 and Stage II Engines

To confirm which engine your tractor is equipped with, see RECORD ENGINE SERIAL NUMBER in Identification Numbers Section 180 in this Operator's Manual.

Recommended oil and filter service intervals are based on a combination of oil pan capacity, type of engine oil and filter used, and sulfur content of diesel fuel. Actual service intervals also depend on operation and maintenance practices.

Use oil analysis to evaluate the condition of the oil and to aid in selection of the proper oil and filter service interval. Contact your John Deere dealer for more information on engine oil analysis.

Change the oil and oil filter at least once every 12 months even if the hours of operation are fewer than the otherwise recommended service interval.

Diesel fuel sulfur content affects engine oil and filter service intervals.

• Use of diesel fuel with sulfur content less than 500 mg/kg (500 ppm) is RECOMMENDED.
• Use of diesel fuel with sulfur content 500—5000 mg/kg (500—5000 ppm) REDUCES the oil and filter change interval.
• BEFORE using diesel fuel with sulfur content greater than 5000 mg/kg (5000 ppm), contact your John Deere dealer.

IMPORTANT: To avoid engine damage:

• Reduce oil and filter service intervals by 50% when using biodiesel blends greater than B20. Oil analysis may allow longer service intervals.
• Use only approved oil types.

Approved Oil Types:

• “Plus-50 Oils” include John Deere Plus-50™ II and John Deere Plus-50.
• “Other Oils” include John Deere Torq-Gard™, API CJ-4, API CI-4 PLUS, API CI-4, API CH-4, ACEA E9, ACEA E7, ACEA E6, ACEA E5, ACEA E4, and ACEA E3.

NOTE: The 500 hour extended oil and filter change interval is only allowed if all of the following conditions are met:

• Use of diesel fuel with sulfur content less than 500 mg/kg (500 ppm).
• Use of John Deere Plus-50™ II or John Deere Plus-50 oil.
• Use of an approved John Deere oil filter.

Engine Oil and Filter Service Intervals
Fuel Sulfur	Less than 500 mg/kg (500 ppm)
Plus-50 Oils	500 hours
Other Oils	250 hours
Fuel Sulfur	500—5000 mg/kg (500—5000 ppm)
Plus-50 Oils	400 hours
Other Oils	150 hours
Fuel Sulfur	5000—10 000 mg/kg (5000—10 000 ppm)
Plus-50 Oils	250 hours
Other Oils	125 hours
Oil analysis may extend the service interval of “Other Oils”, to a maximum not to exceed the interval for Plus-50 Oils.