OMRE560318

Symptom	Problem	Solution
Insufficient transport clearance	Center link too long	Adjust center link
	Lift links too long	Adjust lift links
	Implement not level	Level implement
	Implement not correctly adjusted	See implement operator's manual
	Upper height limit not correctly set	Adjust upper height limit

Hitch fails to follow lever

Malfunction in lever position sensor circuit or hitch position sensor

See your John Deere Dealer

Poor position control	Load/depth mix control on wrong position	Turn load/depth mix control to the left
	System is reset	Enable system
	Calibration fuse inadvertently moved	Be sure key switch is OFF and move fuse to spare position
	Malfunction in lever position sensor circuit or hitch position sensor	See your John Deere Dealer

Hitch drops slowly

Hitch rate-of-drop control not correctly set

Adjust rate-of-drop knob

Hitch fails to lift or lifts slowly	Excessive load on hitch	Reduce load
	Center link in wrong position	Adjust upper height limit

Implement will not operate at desired depth	Lift links too short	Adjust lift links
	Lack of penetration	See implement operator's manual
	Draft sensor failed	See your John Deere Dealer

Insufficient or no hitch response to draft load	Load/depth mix control in wrong position	Turn load/depth mix control to the right
	System is reset	Enable system
	Rate-of-drop too slow	Adjust rate-of-drop knob

Hitch too responsive

Load/depth mix control not correctly set

Turn load/depth mix control to the left

Hitch settles too fast after tractor is parked and engine is shut off

Internal circuit leakage

See your John Deere Dealer

Hitch will not move (controls not working, including rear raise/lower switch)	Fuse(s) blown	Replace fuses
	Engine not running	Start engine

Rear raise/lower switch will not move hitch	Failure of raise/lower switch, connector, or wiring harness	See your John Deere Dealer
	Lever in transport	Move lever out of transport

RW29387,0000780-19-20100727