Requirements for Powershift Transmission

Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in the Operator's Manual of the implement. Transfer control using AutoTrac™ resume switch or TIA resume softkey as presented in Operating Tractor Implement Automation of this section.

• The implement can accelerate the tractor up to the limit set by the operator.

NOTE: The limit is determined by the maximum speed setting and the set speed adjusting wheel; this limit set by the operator cannot be exceeded by the implement.

To transfer control to the implement, the following preconditions have to be met:

• Operator sitting on seat.
• No malfunctions present with Powershift Transmission.
• Shift lever must be in Forward.

NOTE: When transferring control to the implement, Efficiency Manager™ mode will engage.

To withdraw control using the shift lever:

• During driving: Shift up or down manually.
• Increasing the speed can end the Auto Mode. The implement has all information to inform the operator that this intervention will end the travel speed Auto Mode (see implement Operator's Manual).

NOTE: Reducing the speed is always allowed.

It is allowed to increase the limit set by the operator within 2 seconds after starting the travel speed Auto Mode.

The current travel speed can be limited by other processes (e.g. iTEC ™). This limit will be observed, however, it will not be considered as an intervention by the operator.