Service Interval Chart—Daily or 10 Hour, 50 Hour, 100 Hour, 250 Hour, 500 Hour and 1000 Hour

Item

Daily or 10 Hours

50 Hours

250 Hours

500 Hours

1000 Hours

Check Engine Oil Level

       

Check Transmission-Hydraulic Oil Level

       

Lubricate MFWD or TLS™ Plus King Pins, Tie Rod Ends, Steering Cylinder, Axle Pivot and Panhard Rod1

   

 

Lubricate MFWD or TLS™ Plus External Fittings and U-Joints (If Equipped)1

   

 

Inspect Tires

 

     

Lubricate Rear Hitch Components (If Equipped)2

 

   

Lubricate Front Hitch (If Equipped)2

 

   

Check Manual Brakes3

   

   

Check Neutral Start System

   

   

Check Transmission PARK System

   

   

Check Front PTO Housing Oil Level (If Equipped)

   

   

Change Engine Oil and Filter4

     

 

Back Flush Optional Fuel Water Separator (If Equipped)

     

 

Service Severe Duty Water Separator (If Equipped)

     

 

Lubricate Cab Suspension (If Equipped)

     

 

Tighten Wheel and Wheel Weight Bolts

     

 

Inspect Air Intake System

     

 

Clean Dual Beam Radar Sensor (If Equipped)

     

 

Replace Fuel Filters

     

 

Replace Cab Fresh Air and Recirculation Filters5

       

Test Coolant Freeze Point5

       

Check TLS™ Plus Accumulator Charge Pressure (If Equipped)

       

Check Cab Suspension Accumulator Charge Pressure (If Equipped)5,6

       

Clean MFWD or TLS™ Plus (If Equipped) Axle Breather7

       


TLS is a trademark of Deere & Company
1 Normal lubrication at 500 hours. If used in extremely wet conditions, lubricate daily or every 10 hours.
2 Normal lubrication at 250 hours. If used daily, lubricate every 50 hours.
3 If tractor not equipped with electronic back-up pump.
4 Perform oil change in accordance with Engine Oil and Filter Change Intervals in Fuel, Lubricants and Coolant section of this Operator's Manual.
5 Perform service every 1000 hours or annually - whichever comes first.
6 See your John Deere™ dealer.
7 Interval may vary according to operating conditions.

TO84419,0000073-19-20140715